Clean the Resin Tank¶
Please maintain and clean the resin tank regularly to maximize its performance and to ensure consistent, high-quality prints over a tank's lifetime.
Danger
Resin may cause skin irritation or an allergic skin reaction, so please wear gloves when handling liquid resin or resin-coated surfaces and wash skin with plenty of soap and water.
Please follow the instructions below to cure and remove residues at the bottom of the resin tank.
① Place the resin tank cleaner in the corner.
② Go to Settings > Hardware Settings > 光机 Settings or Home > Resin Tank Information, tap Cure Resin and set Curing time.
③ After curing is finished, loosen the buckle and gently remove the resin tank.
④ Wear disposable gloves and remove the cured resin layer from the bottom with the resin tank cleaner, as shown in the right figure.
Note
If there are still some residues floating, use an 80 to 100 mesh filter to filter the residues.
Caution
The bottom of the resin tank is made of a single layer of FEB film which is easy to be broken. Therefore, when removing the solid resin layer, be careful not to poke the bottom of the tank.
Please follow the instructions below to clean the exterior surface of the resin tank.
① Empty the liquid resin from the resin tank into the original container.
② Use the brush soaked by ethanol and the cloth to clean the liquid resin on the surface.
Caution
The inner side of the resin tank is equipped with an NFC chip, which is used to sense the resin material in the tank and write the tank information. To avoid damaging the chip, be careful to avoid the chip's adhesive location when cleaning the resin tank with an ethanol solution.
After cleaning, lay the resin tank in a cool ventilated place for drying it completely before the next use.