Manual setup¶
Note
- When comparing the original state with programs or comparing programs, Manual setup is supported. Please select the certain program on the pop-up window.
- In the original state, if the user adjusts the teeth and confirm the adjustment, a new program will be created. If there is already 3 programs, then manual setup is not supported in the original state.
Through manual setup, the user can adjust the simulated orthodontic effect and customize individual teeth according to specific requirements.
Click 
on the top of the main interface when selecting only one program to enter Manual setup interface.
After adjustment, click Confirm to save the changes.
Manually adjusting indexes of the dental arch by dragging the slider is supported.
When checking the teeth model, click 
to adjust indexes of the dental arch.
When checking the facial model, click 
, 
, 
to respectively adjust width of dental arch, length of dental arch and lip inclination of upper anterior teeth.
Use 
Shift, 
Rotation and 
Torsion to adjust the teeth.
Drag the slider to adjust the sensitivity.
Click 
to check and adjust the interval between the adjacent teeth.
-
There is a point on the contacting part of adjacent teeth. Different colors indicate different intervals.
-
Click one point and adjust the interval by β and β.
-
The tags showing the intervals can be pressed and dragged to anywhere to avoid blocking the model.
Note
Only Tooth Model can check and adjust interproximal contact.
