Multidie Case¶
Die Order¶
Create the Order¶
Order Information¶
1 Click 
to enter the order page.
2 Fill in the blanks and select the doctor and the technician from the list. If there is no targeted doctors and technicians, click 
to add them.
3 Select Restoration as the dentistry type.
4 (optional) Add notes.
Tooth Selection¶
1 Select Multidie Mode.
2 Click the hole in the fixture of the tooth die.
3 Select the type of restoration.
Note
● Click the right mouse button (RMB) to cancel the selected type of restoration one by one.
● Click Clear All to cancel all selected types.
4 Click Scan to start or click Save to save the order and scan it later.
Start Scanning¶
Die Scan¶
1 Follow the guidance on the interface to place the height adaptor and the model.
2 Set the configuration in the camera window.
3 (Optional) Turn on additional functions.
● 
: Add details and process a high-quality scan.
4 Click 
or press the space key to start scanning.
5 After scanning, move or rotate the cutting plane to cut the model. Failure to remove the unnecessary jig data (the red part in below picture) may cause misalignment later.
6 Click 
to edit the model.
7 Click 
to save the edit and return to the scanning interface.
8 Click 
to preview the scanned model;
or click 
to rescan;
or click 
to finish.
Finish Scanning¶
After finishing the scanning process,click on Go to Pre-design to edit the scanned data.
Waxup Order¶
Create the Order¶
For steps to create a multidie order, see Multidie Case-Create the Order.
Start Scanning¶
Wax-up Scan¶
1 Follow the guidance on the interface to place the height adaptor and the model.
2 Set the configuration in the camera window.
3 (Optional) Turn on additional functions.
4 Click or press the space key to start scanning.
5 After scanning, move or rotate the cutting plane to cut the model.
6 Click to edit the model.
7 Click to save the edit and return to the scanning interface.
8 Click to preview the scanned model;
or click to rescan;
or click to finish.
Die Scan¶
1 Follow the guidance on the interface to place the height adaptor and the model.
2 For scanning details, see the last scanning step on Wax-up Scan.
Wax-up Alignment¶
1 Check the automatic alignment and click to finish.
2 If the result is not optimal, click 
and align the scanned data manually.
Finish Scanning¶
After finishing the scanning process,click on Go to Pre-design to edit the scanned data.