Wax-up Scan

Two ways to add the wax-up scanning step.

1 Select Anatomic Waxup, Reduced Waxup, or Pontic Waxup as the restoration type on the tooth selection page. Then Scan Wax-up is enabled by default.

2 Add the wax-up scanning step in the scanning interface.
⑴Click Click.
⑵Check Wax-up.
⑶Click Apply.

Note

If Scan Wax-up is enabled when creating the order, the wax-up scanning step can't be cancelled in the workflow setting.

Note

Please do not delete the model data when editing, especially in edentulous cases, which may cause misalignment later.