Skip to content

Pre-op Scan

Two ways to add the pre-op scanning step.

  1. Click the slider to add the pre-op scanning step in the tooth selection page.


  2. Add the pre-op scanning step in the scanning interface.
    ⑴Click .
    ⑵Check Pre-op.
    ⑶Click Apply.

Note

  • If Scan Pre-op is enabled when creating the order, the pre-op scanning step can't be cancelled in the workflow setting.
  • If Scan Pre-op is enabled, (Waxup/Pre-op) Bite can be checked in the workflow setting. Once enabled, the occlusion alignment will be accessible by aligning pre-op upper/lower jaw and bite model.