Mesh¶
After editing the point cloud data, tap 
to manually set the mesh parameters.
Settings¶
| Function | |
|---|---|
| Resolution | Closer point distance indicates higher resolution and more geometric details shown in 3D mesh model. You can manually drag the slider  to adjust the resolution, or directly check  to use recommended values.Besides, tap  to enter the high-detail mode, where you can tap  /  to adjust the resolution. NotePlease use EXScan Rigil software on a computer with > 32 GB of RAM for higher resolution. |
| Mesh Smoothness | Reduce noise on the surface of the model. The higher the smoothing level is set, the smoother the data surface is and the more data details are lost. |
| Remove Small Floating Parts | Delete any small disconnected data from the main data. |
| Fill Markers | Automatically fill all the area covered by markers. Enabled by default, and cannot be disabled when the Watertight function is enabled.  NoteIf Marker alignment is not enabled, this setting will be invisible. |
| Texture Mapping | Apply colors and textures to the surface of the model.Note This setting will not be displayed for the project without Acquired Texture. |
| Watertight | Choose whether to fill all holes and wrap up all open areas on the surface of the model. |
Note
- After generating the mesh, tag
to clip the data again to make it more accurate. - After generating the mesh, all settings cannot be adjusted; you can switch to point cloud and mesh again.