Mesh Interface

After meshing, you can edit the mesh in the mesh interface. For specific functions, see the table below.

Overview

Function	Description
Point Cloud / Mesh	Tap the corresponding button to switch the current data to point cloud or mesh.
	Tap this button to rename the current project.
	Tap this button to return to the scan interface and continue scanning. Note After returning to the scan interface, it does not support switching the scan mode of the project or rolling back previously edited data.
	Tap this button to enter the clipping interface to clip the data and remove noise data.
	Tap this button to align the model to make it easier to measure the bounding box and perform other post-processing operations. For details, please refer to Alignment.
	After tapping this button, you can choose to turn texture display on or off. Note Only projects that have turned on Acquired Texture can support turning on texture display.
	Tap this button to restore the model to its original size and center it on the screen.
	Tap this button to open the Mesh Editing window. Here, you can adjust the texture and fill the holes. For details, please refer to Mesh Editing.
	Tap this button to do texture mapping. Note This function is unavailable if you did not enable Acquire Texture before scanning.
	Tap this button to measure the model; see Measurement for details.
Complete	Tap this button to save the current project and return to the Scan interface.
Delete	Tap this button to delete the data of the current project. Note After deleting data, it cannot be restored again.