Skip to content

Measure

After generating the mesh, in the interface of Mesh, you can tap thebutton in the right-side function bar to enter the Measure interface, where you can measure the surrounding box (default) and distance.

Note

When Texture Mapping is enabled, Texture Display is enabled by default and can be disabled manually.

Measure Bounding Box

Col

In the Measure interface, tapbutton in the right-side function bar to show the bounding box, whose length (mm), width (mm) and height (mm) will also be shown.

Col

Note

The model can be panned, rotated or scaled ( Reset View function can be used to reset the model to its original position).

Measure Distance

In the Measure interface, tapbutton in the right-side function bar to enable the function for measuring the distance.
The steps for measuring the distance are as follows:

Col

  1. Usepoint mode (default) and tap any position on the model to add 2 points.
    Note
    You can switch torotation mode, when the model can be panned, rotated or scaled ( Reset View function can be used to reset the model to its original position).
  2. After 2 points are added, they will be automatically connected, and the straight line distance (mm) will be displayed; if you add another point, the previous connection will be removed, and a new line will start from the new point.
  3. (Optional) When there are existing lines, the Geodesic function can be enabled to calculate geodesics.

Col

Note

  • You can drag the points to adjust their position, and the distance value will be updated in real time; you can drag the points to activate the magnifying glass function, which can be used to zoom in and display a specific part of the model, which can help you define the measurement point more precisely.
  • If the added two points are not on the same surface, the Geodesic function can not be enabled.