Mesh¶
In the interface of point cloud edit, you can tap 
to perform one-click processing, including 
Fast (offer faster meshing) and 
HD modes, and mesh & texture map will be automatically generated using recommended parameters.
Besides, you can also tap 
in the right-side function bar to enter the process of mesh generation and manually edit the mesh.
Note
- The mesh data can be subsequently used for rendering or 3D printing.
- Only the project with texture acquired supports one-click texture mapping; if the Acquire Texture function is not enabled, then only mesh will be automatically generated.
- If the current project uses the marker alignment mode, markers will be automatically filled for one-click processing.
- If the current project has already generated the mesh, it will be overwritten after one-click processing.
- During the one-click processing and mesh generation, you can manually exit the process by tapping the
button in the upper right corner.
Mesh Settings¶
| Setting | Description |
|---|---|
| Watertight | Choose whether to fill all holes and wrap up all open areas on the surface of the model. |
| Resolution | Closer point distance indicates higher resolution and more geometric details shown in 3D mesh model. You can manually drag the slider  to adjust the resolution, and you also can check on  Use recommend value to use the default resolution.Besides, you can tap  to enter the high-detail mode, where you can tap / to adjust the resolution. NotePlease use StarVision software on a computer with > 32 GB of RAM for higher resolution. |
| Mesh Smoothness | Smooth noises on the surface of the model. Four adjustable levels are provided: none, low, middle and high. |
| Texture Mapping | Apply colors and textures to the surface of the model. Disabled by default, and can be enabled manually. NoteThis setting will not be displayed for the project without acquired texture. |
| Fill Markers | Automatically fill all the area covered by markers. Enabled by default, and can not be disabled when the Watertight function is enabled. NoteIf Marker alignment mode is not enabled, this setting will be invisible. |
Tap the Apply button, the mesh will be automatically generated according to the mesh settings, and the generated mesh can be edited; if the generated mesh does not meet your expectation, you can tap 
to return to the scan interface, and a confirmation pop-up will appear to ask whether you want to clear the generated mesh.
Note
- After generating the mesh, all settings can not be adjusted; you can tap
to reset all settings. - If it prompts that "A mesh already exists", you can tap Replace to re-overwrite it with the new mesh.