Calibration Notice

With calibration, the scanner parameters are recalculated, which not only ensures the accuracy of the scanner, but also improves the quality of scanning, including calibration and white balance.

Calibration is required under the following conditions:

• When the scanner is used for the first time.

• The scanner was severely shaken or shocked, such as shocked during transportation.

• Severe accuracy reduction, such as frequent errors in alignment or unrecognized markers.

• Incomplete data is acquired during the scanning or serious deterioration of the quality of scanned data.

Note

• After the calibration completes, will appear next to the "calibration" step button in the navigation bar, and this step will be automatically skipped when you start up this software again.
• If the current device has not been calibrated for more than 14 days, will appear next to the "calibration" step button in the navigation bar; if it has been more than 20 days without calibration, a pop-up window will appear on this interface with the option to Calibrate now or set a reminder for 7 days later.

Warning

• The calibration board is matched to the device. Doing the calibration with an incorrect calibration board will fail to generate good scan data or optimum accuracy.

• Always make sure that both sides of the calibration board are clean and free of scratches.

• Do not place heavy objects or sundries on the calibration board.

• Keep the calibration board away from corrosives, metals and sharp objects to avoid corrosion or damage.

• It is not recommended that you wipe the calibration board. When cleaning the board becomes very necessary, gently wipe it with a piece of a clean damp cloth. Do not use a cloth with chemicals or alcohols to wipe the calibration board.

• After using the calibration board, put it safely in a box or flannel bag.