Mesh Processing

After the scan is completed, click to enter the post-processing > mesh processing interface. Here, you can perform some optimization settings on the scanned data.

Item	Description	Note
Filter	To optimize the data and reduce noises. A filter with high level may cause the data to lose some details.	None: No optimization. Low: Optimizes data slightly and preserves data characteristics. Med: Reduce the noise on the surface of the scanned data High: Reduce the noise on the surface of the scanned data and make the data smoother.
Remove small floating parts	To remove small floating parts unrelated to the model.	Drag the slider or click the arrows to adjust the ratio of removing small floating parts. 0 means not to remove them.
Max triangles	To set a max plate number as an upper limit to simplify the data.	Input an appropriate number.
Fill small hole	To auto fill the small hole according to its perimeter.	The default perimeter equals to or is less than 10 mm. You can adjust it according to your requirements.
Remove spike	To remove spikes and unfold the single spike in the polygonal mesh.	/
Marker hole filling	To fill in holes in the surface of the object that are covered by markers and therefore are not scanned.	/
Recommended parameters	To use recommended optimized data when enabled.	/

Button	Description
Apply	Click on Apply to confirm the settings and view the effects of the applied settings. If you need to adjust the effects, you can click on to discard the current operation and start the settings again.
Confirm	Click on Confirm for final confirmation.