Partial HD Scanning

Steps

1. Switch to Partial HD Scanning after acquiring the data in the Scan Mesh.

   Note

   The light source mode will be automatically switched to parallel lines in Partial HD Scanning. You can switch it to cross lines or single line according to the actual situation.

2. Review the scanned data to identify areas that need to be rescanned.

   Note

   Click to view the data from different angles. You can also rotate it by holding down Left Button or move it by holding down Middle Button to confirm the area that needs to be scanned in detail.

3. Select the identified areas and rescan them.

   ① Select , or in the editing bar.

   ② Press and hold Shift + Left Button and then move the cursor to select an area on the scanned object. The selected area will be displayed in red.

4. Set the point distance.

   ① Drag the slider or adjust the point distance by the up and down arrows .

   ② Click Confirm and a second window will pop up for confirmation.

5. Click Confirm and the selected data will be deleted.

6. (Optional) Click or press the scan button on the scanner to preview the model and adjust scan parameters for better scanning effects.

7. Click or press the scan button on the scanner to start scanning.

8. After scanning, click to save the data.