Mesh Processing

After the scan is completed, click or to enter the Post-processing > Mesh processing interface where you can optimize the scanned data.

Item	Description	Note
Optimization	To optimize the data and reduce noises. A filter with high level may cause the data to lose some details.	None: No optimization. Standard: To optimize data slightly and preserves data characteristics. Med: To reduce the noise on the surface of the scanned data. High: To reduce the noise on the surface of the scanned data and make the data smoother.
Smooth	To denoise the data and make it smooth to improve the quality.	When Optimization is set to None, this function is not available.
Remove small floating parts	To remove small floating parts unrelated to the model.	Drag the slider or click the arrows to adjust the ratio of removing small floating parts. 0 means not to remove them.
Edge optimization	By checking it, the boundary data will be more complete and smoother after meshing.	/
Max triangles	To set a max plate number as an upper limit to simplify the data.	Input an appropriate number.
Fill small hole	To auto fill the small hole according to its perimeter.	The default perimeter equals to or is less than 10 mm. You can adjust it according to your requirements.
Remove spike	To remove spikes and unfold the single spike in the polygonal mesh.	/
Marker hole filling	To fill in holes in the surface of the object that are covered by markers and therefore are not scanned.	/
Recommended parameters	To use recommended optimized data when enabled.	/

Button	Description
Preview	Click Preview to preview the effects after applying the settings. If adjustments are needed, click to discard the current operation and reconfigure the parameters.
Confirm	Click Confirm for final confirmation.