Skip to content

Mesh Processing

After the scan is completed, click or to enter the Post-Processing > Mesh Processing interface where you can optimize the scanned data.

Item
Description
Optimization To optimize the data and reduce noises. A filter with high level may cause the data to lose some details.
Note
  • None: No optimization.
  • Low: To optimize data slightly and preserves data characteristics.
  • Standard: To reduce the noise on the surface of the scanned data.
  • High: To reduce the noise on the surface of the scanned data and make the data smoother.
    		•
    Smooth To denoise the data and make it smooth to improve the quality.
    Note
    When Optimization is set to None, this function is not available.
    Remove small floating parts To remove small floating parts unrelated to the model.
    Note
    Drag the slider or click the arrows to adjust the ratio of removing small floating parts. 0 means no removement.
    Item
    Description
    Trim Optimization After checking, the boundary generation of sheet metal parts can be optimized.
    Optimize Recognized Feature After checking, the edge data of holes can be optimized.
    Thickness Offset Edit the thickness offset values on the data model, such as edges and holes, to optimize the model.
    Item
    Description
    Edge optimization By checking it, the boundary data will be more complete and smoother after meshing.
    Max triangles To set a max plate number as an upper limit to simplify the data.
    Note
    Input an appropriate number.
    Fill small hole To auto fill the small hole according to its perimeter.
    Note
    The default perimeter equals to or is less than 10 mm. You can adjust it according to your requirements.
    Remove spike To remove spikes and unfold the single spike in the polygonal mesh.
    Marker hole filling To fill in holes in the surface of the object that are covered by markers and therefore are not scanned.
    Recommended parameters To use recommended optimized data when enabled.
    Button
    Description
    Preview
  • Click Preview to preview the effects after applying the settings.
  • If adjustments are needed, click to discard the current operation and reconfigure the parameters.
    		•
    Confirm Click Confirm for final confirmation.