Projector Focus¶
When frequently encountering calibration failures or poor scanning data quality due to the unclear LED stripe pattern, it is recommended that you adjust the projector focus.
Note
- After completing the projector focus, please recalibrate.
- If the issue persists after focusing the projector, please contact our technical support.
The operation steps for projector focus are as follows:
-
Select Wide Mode or Precise Mode according to the current scanning mode.
-
Adjust the brightness of the left and right cameras using the slider or stepper;
Auto exposure (enabled by default) is supported to optimize the captured images.
-
According to the orientation illustration, adjust the distance of the calibration board until the laser points overlap, and place the calibration board in the center and forward; when the interface indicates the status as "
", you can click the Focus button to start the focusing.
-
Check the focusing results. If you need to use the Monocular-Stereo Fusion function, it is recommended that you recalibrate the device.
Note
If it prompts "Focus failed", please do troubleshooting according to the given failure reasons or contact the technical support.