Skip to content

Scan Preview

After powering on the device, you can enter the interface of scan preview.

Note

If this is your first time to enter the interface of scan preview, you will be automatically directed to the User Tutorial interface:
Tap button to enter the next step of the tutorial, tap button to return to the previous step of the tutorial; in the final step, tap Start calibration to enter the actual calibration process. You also tap Skip to skip the tutorial, which can be checked again through Personal Center > Help Center.

Interface Overview

Note

For the introduction to the top status bar, see status bar.

① Scan Mode

Tap buttons to switch the scan mode of the current project:

  • : HD scan (default).
  • : Fast scan.

② Project Information

Display the data information (fps, frames and points) and parameter settings of the current project:

  • / : Object / Portrait scan mode.
  • : Feature alignment mode.
  • : Texture alignment mode.
  • : Markers alignment mode. Tap Advanced Settings button in the right-side function bar to adjust parameter settings of the project.

③ Scan Settings

Set camera view, scanning distance, data quality indicator and texture display. For more, see scan settings.

④ Model Preview

Display the model's pre-scanning effect; if Markers alignment mode is enabled, the identified markers will appear on the model.

Note

In the scan preview state, operations such as scaling, translating, and rotating the model are not supported.

⑤ Distance Indication

Green indicates that the distance is appropriate, red indicates that the distance is too near, blue indicates that the distance is too far.

Note

If it prompts that "The distance is too close / too far" or "Unable to collect data", please adjust the distance.

⑥ Function Buttons

: The entrance to Advanced Settings.
: The button to start scanning.
: The entrance to file list.