Mesh

In the interface of point cloud edit, you can tapto perform one-click processing, including Fast (offer faster meshing) and HD modes, and mesh & texture map will be automatically generated using recommended parameters.

Besides, you can also tapin the right-side function bar to enter the process of mesh generation and manually edit the mesh.

Note

• The mesh data can be subsequently used for rendering or 3D printing.
• Only the project with texture acquired supports one-click texture mapping; if the Acquire Texture function is not enabled, then only mesh will be automatically generated.
• If the current project uses the markers alignment mode, markers will be automatically filled for one-click processing.
• If the current project has already generated the mesh, it will be overwritten after one-click processing.

Mesh Settings

Setting	Description
Watertight	Choose whether to fill all holes and wrap up all open areas on the surface of the model.
Resolution	Closer point distance indicates higher resolution and more geometric details shown in 3D mesh model. You can manually drag the slider to adjust the resolution, and you also can check on Use recommend value to use the default resolution. Besides, you can tap to enter the high-detail mode, where you can tap/ to adjust the resolution. Note If you need to use higher resolution for large volume of data, it is recommended that you use StarVision to mesh model on the PC with higher performance.
Mesh Smoothness	Smooth noises on the surface of the model. Four adjustable levels are provided: none, low, middle and high.
Texture Mapping	Apply colors and textures to the surface of the model. Disabled by default, and can be enabled manually. Note This setting will not be displayed for the project without acquired texture.
Fill Markers	Automatically fill all the area covered by markers. Enabled by default, and can not be disabled when the Watertight function is enabled. Note If Markers alignment mode is not enabled, this setting will be invisible.

Tap the Apply button, the mesh will be automatically generated according to the mesh settings.

Note

• After generating the mesh, all settings can not be adjusted; you can tapto reset all settings.
• If it prompts that "A mesh already exists", you can tap Replace to re-overwrite it with the new mesh.